Črte na slikah

Michkena

Pripravnik
4. avg 2007
763
-9
16
aparat je začel delat slikce z navpičnimi črtami (najbolj vidnimi na temni podlagi), poškodovan ni bil, ne dela pa črt na vseh slikah, kje je finta?
canon S1.
 

Lecter

Pripravnik
26. jul 2007
598
0
16
Linije so vidne, ko das slike na racunalnik ali ze prej?
Lahko bi prislo do napake pri prenosu.

Drugace mu verjetno mu ni vec pomoci. Gledam malo po netu in to se dogaja. Ljudje so posiljali na servis, ta pa ni naredil nic.
 

luka51

Guru
16. avg 2007
14.411
5.686
113
nesi na servis. zadeva bo popravlena brezplačno. je serijska napaka na teh aparatih.
nekaj se senzor odlepi al nekaj zakega.
meni so na prastarem a75 menjali brez blemov lani
 
Nazadnje urejeno:

Lecter

Pripravnik
26. jul 2007
598
0
16
Mogoce je nas servis res boljsi kot ameriski (kar mora biti redkost). Tam ocitno niso menjali. Isti problem so imeli tudi mocnejsi modeli.
 

luka51

Guru
16. avg 2007
14.411
5.686
113
jaz sem samo napisal kako je blo. meni je crkno in sem ga že odpisal, potem pa nek snanec vpraša kaj naj ker mu na a85 neke črte pušča (oba seveda že dolgo ne več v garanciji). pa poguglam in vidim da je menjava zastojn. kličem na a3 al kaj je pri nas za canon. rečejo ni problema prinesite in bomo menjali.
brez vsakih vprašanj brez vsega. ko sem fotoaparate dvignil sem vprašal kaj je blo. pa mi je razložo da je neka napaka v lepilu in se v zahtevnem okolju (vroče in vlažno) pač odlepi.
in jaz to govorim iz lastnih izkušenj, ti lecter pa iz usa forum izkušenj
če ti to ni dovol maš pa še uradno canonovo obvestilo

torej komu je zdaj za verjet?

PowerShot S1 IS

This Service Notice will update Canon U.S.A., Inc.'s previous CCD Image Sensor Advisory, dated October 6, 2005.

It has come to our attention that the vendor-supplied CCD image sensor used in certain Canon digital cameras and digital video camcorders may cause the following malfunction: When the product is used in recording or playback mode, the LCD screen and/or electronic viewfinder may exhibit either a distorted image or no image at all. While reports of this malfunction have been rare in the United States, we have determined that it may occur if the product is exposed to hot and humid environments.

Notice of Additional Affected Products:
As a result of our continuing investigation of this malfunction, we have determined that the 11 models listed below, in addition to the 16 models listed in our Service Notice concerning this malfunction, dated October 6, 2005, may be affected.

Affected products:
- Camcorders: ZR60, ZR65 MC, ZR70 MC, ZR80, ZR85, ZR90, ELURA 40 MC, ELURA 50
- Digital Cameras A60, A70, A75, A300, A310, S230, SD100, SD110, A40(*), A80(*), A85(*), A95(*), S1 IS(*), S60(*), S200(*), S330(*), S400(*), S410(*), S500(*)
*Models added as of Oct.31, 2006

Malfunction:
It has been confirmed that the connecting parts of the internal wiring of the CCD used in affected products may become disconnected, especially if the affected products are stored or used in high-temperature and high-humidity environments. If this occurs, the signal is not output from the CCD normally in Shooting Mode, which may cause a distorted image or the absence of an image. This malfunction can be confirmed on the LCD monitor screen during shooting. The same malfunction also appears on the recorded image.

Canon's Response:
Effective immediately, and regardless of warranty status, Canon will repair, free of charge, the products listed above exhibiting the above-mentioned malfunction if Canon determines that the malfunction is caused by the CCD image sensor. Canon will also cover the cost of shipping and handling in connection with this repair.

U.S. residents are kindly directed to contact the Canon Customer Support Center for further assistance at 1-800-828-4040. Support hours are Monday thru Friday - 8:00 AM to 12:00 midnight; and Saturday 10:00 AM to 8:00 PM (all times EST). Alternatively, if electronic support is preferred, please send your email to carecenter@cits.canon.com This information is for residents of the United States of America and Puerto Rico only.

If you do not reside in the USA or Puerto Rico, please contact the Canon Customer Support Center in your region.

We sincerely apologize for any inconvenience caused by this issue, and appreciate your understanding in this matter. Thank you for your support and patronage of Canon products.
 
Nazadnje urejeno:

MrDaco

Guru
11. sep 2007
11.764
5.913
113
Jaz imam doma starega ixus 400. In so se mi začele pojavljat črte. Si rečem če je hin je hin in kupim novo sx200tko. Potem sem pa mimogrede zvedel za serijsko napako. Pokličem na 3A, jim povem da ima serijsko napako in mi rečejo naj samo pošljem in da bodo sami pregledali kaj je narobe. In čez en teden dobim nazaj popravljenega.